Installation and Tuning Instructions
500 CFM Circle Track Two Barrel Carburetor
Thank you for purchasing a Quick Fuel Technology 500 CFM carburetor for circle track
applications. We have tried to incorporate many of the same features used in our highly
successful Sportsman, Late Model and Super Truck Series Two Barrel carburetors.
These upgrades will save you a great deal of time and inconvenience often required to
convert a stock carburetor for circle track use. Fuel flow and float level control are two
critical factors in achieving good on-track performance. Your carburetor is equipped
with a “state of the art” molded float that ensures fuel flow no matter how hard your car
or truck corners. Your carburetor also is equipped with a “shortie” vent whistle to
prevent fuel slosh exiting the fuel bowl through the vent tube.
1. Always use the flange gasket provided with your carburetor. Using the incorrect
flange gasket often results in substandard performance.
2. If your racecar or truck is not equipped with a positive wide open throttle stop please
consider this inexpensive device. The throttle lever is welded to the throttle shaft,
however, repeated wide open throttle use without a positive stop will eventually begin
to create slop in the throttle lever, resulting in inconsistent performance.
3. Always check your accelerator linkage to be sure it is pulling the throttle lever
straight. Any variation from the correct alignment will cause side loading of the
throttle lever and shaft, causing premature wear.
4. We recommend the use of a spring mounting bracket that bolts to the throttle body
and ensures a straight horizontal spring pull on the throttle lever. Your carburetor has
been modified by tapping a ¼”-20 hole in the throttle body to accommodate this
bracket. In addition, you may have to remove or straighten the solenoid tab on the
throttle lever to allow you to connect the return springs (always use two (2) for safety
reasons) to the large eye in the throttle lever.
5. After installation and initial start up, allow the engine to reach operating temperature.
Once the engine has reached operating temperature, with the engine running, check
the float level by slowly removing the fuel level sight plug. Have a shop rag handy to
catch any excess fuel that may leak out when you remove this plug. Although we
have already set the float level, the level will vary from one application to another due
to changes in fuel pressure.
6. If the float level needs to be changed, with the externally adjustable needle and seat.
Caution: the adjustment nut and lock screw are directly exposed to fuel under
pressure. Slightly loosen the lock screw (less than 1/8 turn) and turn the adjustment
nut (5/8” wrench) to raise (turn the nut counter-clockwise {left}) or lower (turn the
nut clockwise {right}). Caution: as you turn the adjustment nut, continually
retighten the lock screw to minimize fuel leakage.
7. Adjust the idle mixture screws to achieve the best idle quality.
8. You are now ready to try out your new carburetor. Your carburetor is equipped with
# 72 main jets, a #45 power valve and a #28 accelerator pump discharge nozzle.
© Quick Fuel Technology 1999
(1 pages)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Commentaires sur ces manuels