Quick-fuel-technology Carburetor Main Body Manuel d'utilisateur télécharger pdf

Carburetor Main Body Installation Instructions

To properly install your new carburetor main body please follow these

simple step-by-step instructions. Please use proper safety precautions when

handling gasoline.

1. After removing the carburetor from the engine, drain all gasoline from

the fuel bowls. This can be accomplished by removing one of the lower

fuel bowl screws and allowing the fuel to drain into an approved

container. With a funnel, turn the carburetor upside down; activate the

throttle several times to drain the fuel out of the accelerator pump

cavities.

2. Before proceeding any further, you should check to be certain that your

new carburetor main body will fit your carburetor. With your carburetor

upside down, measure the diameter of the venturi at its lowest point

(where it attaches to the throttle body). This measurement should be

equal to that of your existing throttle body, i.e. 1.69” or 1.75”

3. Once the fuel bowl has been emptied, you can now remove the remaining

three fuel bowl screws.

4. With the fuel bowl screws removed attempt to separate the fuel bowl,

metering block from the main body. If these components cannot be

removed by hand it is likely your carburetor has been assembled with

“sticky” adhesive coated gaskets. NOTE: vacuum secondary carburetors

will have a secondary metering plate. The six retaining screws can be

removed with a #3 Clutch Head screwdriver.

5. Separating these components can be somewhat difficult but not

impossible. With a soft-faced hammer, tap repeatedly on the sides of the

fuel bowl and metering block in an effort to break the gasket seal. If this

method proves to be unsuccessful it will then become necessary to pry

the components apart. This is a last resort, when all other methods fail.

Wedge a large blade, common tip screwdriver between the air cleaner

ring and the center the metering block. With a gentle rocking motion,

push the metering block away from the main body. Once the fuel bowl

and metering block separate from the main body turn over the assembly

and attempt to pry the metering block away from the fuel bowl, using the

accelerator pump housing as an anchor and press outward on the

1 2 3

P/N 99-24 3

Résumé du contenu

Page 1

Carburetor Main Body Installation Instructions To properly install your new carburetor main body please follow these simple step-by-step instructi

Page 2

accelerator pump boss on the bottom of the metering block (where the aluminum plug is located). 6. Now remove the throttle body from the main body, u

insert the fuel bowl screws. Tighten in a criss-cross pattern to a target torque value of 30 inch pounds (2.5 ft. lbs.). It is important these screw

Commentaires sur ces manuels

Pas de commentaire

Quick-fuel-technology Carburetor Main Body Manuel d'utilisateur

Naviguer en ligne ou télécharger Manuel d'utilisateur pour Pour la voiture Quick-fuel-technology Carburetor Main Body. Quick Fuel Technology Carburetor Main Body User Manual [de] Manuel d'utilisatio

Résumé du contenu

Commentaires sur ces manuels

Produits connexes et manuels pour Pour la voiture Quick-fuel-technology Carburetor Main Body